Installing A Power Supply Unit; Installation Location Of Power Supply Unit; Installable Power Supply Units - Fujitsu PRIMERGY RX200 S4 User Manual

Chapter 6 Installing Internal Options

6.8 Installing a Power Supply Unit

One power supply unit (PSU) is installed in this server by default. Up to two PSUs
can be installed.
By installing two PSUs, the redundant power feature can be enabled.
This section contains notes on adding a PSU, and explains the procedures for
installation, removal, and replacement.
Replace the defective PSU as soon as possible.

6.8.1 Installation Location of Power Supply Unit

Install the PSU in PSU slot 2.
[Rear]

6.8.2 Installable Power Supply Units

The following power supply units can be installed in this server.
Product name
Power Supply Module
170
• Before installing/removing the PSU, turn off the server and all peripheral
devices. Also unplug all power cables from the server ( "1.4.3 Turning Off the
Server" (p.32)). Failure to do so may cause electric shock.
However, when the redundant power function is supported, a defective PSU
can be replaced without shutting down the server.
• Do not insert your hands in the PSU slot when removing the PSU. Doing so
may cause electric shock.
• The PSU is heavy, so handle it carefully.
If you drop it by mistake, injuries may result.
Power supply unit slot 2 (Optional)
Power supply unit slot 1 (installed as a standard feature)
table: List of installable PSUs
PG-PU124
Product ID