Table of Contents
Advertisement
Upgrading second SCSI backplane (1-inch HD subsystems)
Ê Mount the second SCSI backplane in the order shown in figure 52, and
fasten the screws.
Figure 52: Mounting the second SCSI backplane for 1-inch hard disk subsystems
Ê Plug the free connector (ST2) of the I2C bus cable (3) onto the connector X3
on the new SCSI backplane as shown in figure 53.
Ê Connect the delivered SCSI cable (7) to the SCSI-IN connector on the SCSI
backplane 2 as shown in figure 53.
Ê Connect the delivered power cable (2) to the POWER connector on the
SCSI backplane 2 as shown in figure 53.
Ê Connect the power cable (2) to connector X61 on the power backplane.
106
Appendix
U41147-J-Z156-2-76
Advertisement
Table of Contents
