Table of Contents
Advertisement
Installing/removing the floppy disk drive
Figure 69: Removing the floppy disk drive
Ê Pull out the cage with the floppy disk drive and the front panel of the system
unit as far as possible (1), and hold it there.
V
CAUTION!
The cable for the control panel is very sensitive.
Ensure that the cable is not damaged.
Ê Reach behind the pulled out cage and disconnect the data and power cables
from the floppy disk drive.
Ê Remove the four mounting screws.
Ê Take the floppy disk drive out of the cage.
Installing is done in the reverse order.
Ê Close the server again (see chapter "Opening and closing the server" on
page 47).
124
Appendix
U41147-J-Z156-2-76
Advertisement
Table of Contents
