Table of Contents
Advertisement
Safety
Installation and operation
V
CAUTION!
The server automatically sets itself to a voltage in the 100 V to 240 V
range. Make sure that your local voltage is within this range.
This device has a specially approved power cable and must only be
connected to a grounded wall outlet.
Make sure that the grounded wall outlet and the power socket on the
device are both freely accessible.
The power switch does not disconnect the device from the line
voltage. To disconnect the line voltage completely, remove the power
plug from the grounded power outlet.
Connect the device and the attached peripherals to the same circuit
(data loss).
Route the cables in such a way that they do not form a potential
hazard (make sure nobody can trip over them) and that they cannot
be damaged. When connecting a device, refer to the relevant notes
in this manual.
Never connect or disconnect data transmission lines during a storm
(lightning hazard).
Please ensure that no objects (e.g. necklaces, paperclips, etc.) or
liquids can get into the interior of the device (electrical shock, short
circuit).
In emergencies (e.g. damaged casing, elements or cables,
penetration of liquids or foreign matter), switch off the device immedi-
ately, remove the power connector, and contact your sales office or
customer service.
14
Important notes
U41147-J-Z156-2-76
Advertisement
Table of Contents
