Table of Contents
Advertisement
Appendix
10.10 Mounting/removing the chipcard reader
V
CAUTION!
After the installation of a chipcard reader, the serial port COM2 must be
covered with the delivered plastic cover.
Ê Shut down the operating system.
Ê Switch off the server, and disconnect it from the main power supply.
V
CAUTION!
The power switch does not disconnect the device from the line
voltage. To disconnect the line voltage completely, remove the power
plug from the grounded power outlet.
Ê Unlock the server (floorstand model only) (see chapter "Opening and closing
the server" on page 47).
Ê Remove the front doors (floorstand model only) (see chapter "Opening and
closing the server" on page 47).
Ê Remove the top cover, the side cover, and the slot cover (see chapter
"Opening and closing the server" on page 47).
Ê Remove the front panel (see section "Removing/mounting the front panel"
on page 98).
Figure 70: Removing the chipcard reader
U41147-J-Z156-2-76
Mounting/removing the chipcard reader
125
Advertisement
Table of Contents
