Table of Contents
Advertisement
Operate in API mode
Transmit Request frame - 0x10
Description
This frame causes the device to send payload data as an RF packet to a specific destination.
For broadcast transmissions, set the 64-bit destination address to 0x000000000000FFFF .
n
For unicast transmissions, set the 64 bit address field to the address of the desired destination
n
node.
Set the reserved field to 0xFFFE.
n
Query the NP command to read the maximum number of payload bytes.
n
You can set the broadcast radius from 0 up to NH. If set to 0, the value of NH specifies the broadcast
radius (recommended). This parameter is only used for broadcast transmissions.
You can read the maximum number of payload bytes with the NP command.
Note
Using source routing reduces the RF payload by two bytes per intermediate hop in the source
route.
Format
The following table provides the contents of the frame. For details on the frame structure, see
frame
specifications.
Frame
data
fields
Offset Description
Frame
3
type
Frame ID
4
64-bit
5-12
destination
address
Reserved
13-14
Broadcast
15
radius
XBee/XBee-PRO DigiMesh 2.4 RF Module User Guide
0x10
Identifies the data frame for the host to correlate with a subsequent ACK. If
set to 0, the device does not send a response.
MSB first, LSB last. Set to the 64-bit address of the destination device.
Broadcast = 0x000000000000FFFF
Set to 0xFFFE.
Sets the maximum number of hops a broadcast transmission can occur. If set
to 0, the broadcast radius is set to the maximum hops value.
API frames
API
117
Advertisement
Table of Contents
