Np (Maximum Packet Payload Bytes); Hs (Hardware Series); Hv (Hardware Version); Vr (Firmware Version) - Digi XTend vB DigiMesh User Manual

AT commands

NP (Maximum Packet Payload Bytes)

Reads the maximum number of RF payload bytes that you can send in a transmission.
Using APS encryption (API transmit option bit enabled), reduces the maximum payload size by 9 bytes.
Using source routing (AR < 0xFF), further reduces the maximum payload size.
Note NP returns a hexadecimal value. For example, if NP returns 0x54, this is equivalent to 84 bytes.
Parameter range
0 - 0xFFFF (bytes) [read-only]
Default
N/A

HS (Hardware Series)

Read the device's hardware series number.
Parameter range
N/A
Default
0x2A00 - set in the firmware

HV (Hardware Version)

Display the hardware version number of the device.
Parameter range
0 - 0xFFFF [read-only]
Default
Set in firmware

VR (Firmware Version)

Reads the firmware version on a device.
Parameter range
0 - 0xFFFFFFFF [read-only]
Default
Set in firmware

I/O settings commands

The following AT commands are I/O settings commands.
XTend vB DigiMesh RF Module User Guide
I/O settings commands
59