Default
0x80000
NP (Maximum Packet Payload Bytes)
Reads the maximum number of payload bytes that you can send in a unicast RF transmission based on the
device's current configuration.
Parameter range
0 - 0xFFFF (bytes)
Default
N/A
HV (Hardware Version)
Read the device's hardware version number.
Parameter range
0 - 0xFFFF (read-only)
Default
Set in the factory
VR (Firmware Version)
Reads the firmware version on a device.
Parameter range
0 - 0xFFFFFFFF (read-only)
Default
Firmware-set
I/O settings commands
The following AT commands are I/O settings commands.
CD (GP02 Configuration)
Selects or reads the behavior of the GPO2 line (pin 3).
XTend vB DigiMesh RF Module User Guide
I/O settings commands
44