Pr (Pull-Up/Down Resistor Enable) - Digi XBee DigiMesh 2.4 User Manual

AT commands
Parameter
0
1
2
3
4
5
Default
0

PR (Pull-up/Down Resistor Enable)

PR and PD only affect lines that are configured as digital inputs or disabled.
The following table defines the bit-field map for PR and PD commands.
The bit field that configures the internal pull-up resistor status for the I/O lines. If you set a PR bit to 1,
it enables the pull-up resistor; 0 specifies no internal pull-up. The following table defines the bit-field
map for both the PR and PD commands.
Bit I/O line
0 DIO4/AD4
1 DIO3/AD3
2 DIO2/AD2
3 DIO1/AD1
4 DIO0/AD0
DIO6/RTS
5
6 DIO8/SLEEP_REQUEST
7 DIO14/DIN/CONFIG
8 DIO5/AD6/ASSOCIATE
DIO9/On/SLEEP
9
10 DIO12
11 DIO10/RSSI/PWM0
12 DIO11/PWM1
DIO7/ CTS
13
14 DOUT (pin 2)
XBee/XBee-PRO DigiMesh 2.4 RF Module User Guide
Description
Disabled
N/A
N/A
Digital input
Digital output, low
Digital output, high
I/O settings commands
94