Tr (Transmission Failure Count); Ua (Unicasts Attempted Count); H (Mac Unicast One Hop Time); Mac Broadcast One Hop Time) - Digi XBee DigiMesh 2.4 User Manual

AT commands

TR (Transmission Failure Count)

This value is volatile (the value does not persist in the device's memory after a power-up sequence).
Parameter range
N/A
Default
N/A

UA (Unicasts Attempted Count)

The number of unicast transmissions expecting an acknowledgment (when RR > 0).
This value is volatile (the value does not persist in the device's memory after a power-up sequence).
Parameter range
0 - 0xFFFF
Default
0

%H (MAC Unicast One Hop Time)

The MAC unicast one hop time timeout in milliseconds. If you change the MAC parameters it can
change this value.
Parameter range
[read-only]
Default
N/A

%8 (MAC Broadcast One Hop Time)

The MAC broadcast one hop time timeout in milliseconds. If you change MAC parameters, it can
change this value.
Parameter range
[read-only]
Default
N/A

Network commands

The following commands are network commands.

CE (Routing / Messaging Mode)

The routing and messaging mode of the device.
End devices do not propagate broadcasts and will not become intermediate nodes on a route.
XBee/XBee-PRO DigiMesh 2.4 RF Module User Guide

Network commands

77