Restore The Factory Default Settings - CyberData 011579 Operation Manual

2.5 Restore the Factory Default Settings

The SIP Paging 25V/70V Amplifier is delivered with factory set default values for the parameters in
Table
to the factory default settings.
Note
To restore these parameters to the factory default settings:
1. Use a paper clip to press the RTFM button, bringing up the RTFM screen.
2. Use the toggle button to select Speak IP Address or Restore Defaults, and then Enter to
3. Selecting Restore Defaults will bring up the confirmations screen, where selecting Enter will
4. The device will announce, "restoring default configuration" and "rebooting."
CyberData Corporation
2-3. Use the RTFM switch (see
When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
a
Subnet Mask
Default Gateway
a. Default if there is not a DHCP server present.
activate.
restore defaults.
Confirm that the SIP Paging 25V/70V Amplifier is Up and Running
Figure 2-7) on the front of the unit to restore these parameters
Figure 2-7. RTFM Switch
Table 2-3.
Table 2-3. Factory Default Settings
Factory Default Setting
DHCP
192.168.1.23
admin
admin
255.255.255.0
a
192.168.1.1
931996A
Setting Up the SIP Paging 25V/70V Amplifier
RTFM Switch
Operations Guide
14