Factory Default Settings - CyberData 011324 Series Operation Manual

2.3 Configure the SIP Paging Amplifier Parameters
To configure the SIP Paging Amplifier online, use a standard web browser.
Configure each SIP Paging Amplifier and verify its operation before you mount it. When you are
ready to mount an SIP Paging Amplifier, refer to
instructions.

2.3.1 Factory Default Settings

All SIP Paging Amplifiers are initially configured with the following default IP settings:
When configuring more than one SIP Paging Amplifier, attach the SIP Paging Amplifiers to the
network and configure one at a time to avoid IP address conflicts.
Operations Guide
Table 2-7. Factory Default Settings
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
a
Subnet Mask
a
Default Gateway
a. Default if there is not a DHCP server present.
931971A
Installing the SIP Paging Amplifier
Appendix A, "Mounting the Amplifier"
Factory Default Setting
DHCP
192.168.1.23
admin
admin
255.255.255.0
192.168.1.1
SIP Paging Amplifier Setup
for
CyberData Corporation
24