Factory Default Settings - CyberData 011406 Operation Manual

2.3 Configure the Singlewire InformaCast Loudspeaker
Amplifier Parameters
To configure the Singlewire InformaCast Loudspeaker Amplifier online, use a standard web browser.
Configure each Singlewire InformaCast Loudspeaker Amplifier and verify its operation before you
mount it. When you are ready to mount an Singlewire InformaCast Loudspeaker Amplifier, refer to
Appendix A, "Mounting the Intercom"

2.3.1 Factory Default Settings

All Singlewire InformaCast Loudspeaker Amplifiers are initially configured with the following default
IP settings:
When configuring more than one Singlewire InformaCast Loudspeaker Amplifier, attach the
Singlewire InformaCast Loudspeaker Amplifiers to the network and configure one at a time to avoid
IP address conflicts.
Operations Guide
Singlewire InformaCast Loudspeaker Amplifier (AC-Powered) Setup
for instructions.
Table 2-7. Factory Default Settings
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
a
Subnet Mask
a
Default Gateway
a. Default if there is not a DHCP server present.
931281B
Factory Default Setting
DHCP
10.10.10.10
admin
admin
255.0.0.0
10.0.0.1
Factory Default Settings
CyberData Corporation
24