Charging The Battery Pack - JLG X1000AJ Operation And Safety Manual

SECTION 4 - MACHINE OPERATION

Charging the Battery Pack

DO NOT LEAVE THE MACHINE IN CONTINUOUS CHARGING FOR TIME PERIODS
EXCEEDING 24 HOURS.
REMEMBER, THE CHARGE WORKS EVEN IF THE ELECTRONIC BOARD OF THE
MACHINE IS TURNED OFF. SO THE BATTERIES CAN BE CHARGING EVEN IF THE
REMOTE CONTROL IS OFF.
CHARGE THE MACHINE USING ONLY THE BATTERY CHARGER INSTALLED ON
IT. THE USE OF A CHARGER OTHER THAN THAT PROVIDED VOIDS ANY KIND
OF WARRANTY ON BATTERIES.
Approximate time required to fully recharge the battery
pack:
• Full Recharge -8 hrs. - 120V AC or 4 hrs. - 220V AC
• 80% Recharge -4 hrs. - 120V AC or 2 hrs. - 220V AC
• The batteries can be charged during machine opera-
tion, (obviously the charging times in this case will be lon-
ger).
• The batteries can be charged when they are not fully
depleted.
• If the charge is less than 20% an audible warning signal
will be activated whenever the electric motor is started,
to alert the user to charge the machine.
4-26
• If the charge is less than 10%, in addition
to the audible warning signal, reduced
speed is activated and an icon comes on
in position 4 on the platform station LCD
display.
To start charging the battery connect the main AC power
supply to the AC socket (1) located on the left rear of the
machine next to the electric engine.
After a few seconds the charge indicator (2) located on the
right hand side of the machine on top of the lithium-ion bat-
tery pack turns red, meaning the battery has started charg-
ing.
OL00620
1
3121783