JLG X1000AJ Operation And Safety Manual page 73

SECTION 4 - MACHINE OPERATION
If one of the outriggers does not come into contact with the
ground while being set, the engine will turn off or, the self-
leveling attempt will stop. This situation may be due to the
slope on which the outriggers are being set up on exceeds
the allowed slope for proper set up at the end of the stabili-
zation phase. If the machine is to be lifted even further from
the ground after the outriggers are properly set, push and
hold the outrigger automatic set and level button.
3121783
If the functions are selected when one of the above listed
conditions is missing, an error message will appear on the
platform/remote control display indicating which of the
conditions are OK and which are not. If the condition is that
an outrigger is not set properly, the message will also indi-
cate which outrigger is not set properly.
ST1: if OK outrigger 1 is set properly.
ST2: if OK outrigger 2 is set properly.
ST3: if OK outrigger 3 is set properly.
ST4: if OK outrigger 4 is set properly.
INCL: if OK the machine is set up on an accepted slope.
LOAD: if OK the load in the platform is acceptable.
PLATFORM: if OK the platform/remote control box is in the
proper location in the platform.
PEDAL: If OK the footswitch is correctly depressed.
4-15