JLG X1000AJ Operation And Safety Manual page 159

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
Table 6-12. Inverter Fault Codes
CODE
STBY I high
Cause – Internal fault detected in the inverter.
53
Solution – This is generally a temporary problem due to certain working
conditions. If problem persists, replace inverter.
Capacitor Charge
60 Cause – Internal fault in the inverter.
Solution – Check connections and motor phases.
High temperature
Cause – High temperature inside the inverter.
61
Solution – Improve cooling to inverter. If fault persists, contact JLG after-
sales service.
Motor temperature
65 Cause – High motor temperature.
Solution – Temporarily stop machine to allow motor to cool down.
Can Bus KO
67 Cause – Inverter doesn't receive any information from Can Bus line.
Solution – Check connections using multifunction tester.
Encoder Error
Cause – Problem detected with encoder (=motor speed sensor).
70
Solution – Check speed sensor connection. Anomaly may also have been
caused by fault with bearing.
3121783
DESCRIPTION
Table 6-12. Inverter Fault Codes
CODE
Thermis sensor KO
Cause – Signal from temperature sensor greater than 4.95 Volts or less
73 than 0.1 Volt.
Solution – This is generally a temporary problem due to certain working
conditions. If problem persists, replace inverter.
Driver shorted
Cause – Relay power supply fault.
74 Solution – Check relay power supply. This is generally a temporary prob-
lem due to certain working conditions. If problem persists, replace
inverter.
Driver shorted
Cause – Relay power supply fault.
75 Solution – Check relay power supply. This is generally a temporary prob-
lem due to certain working conditions. If problem persists, replace
inverter.
Coil shorted
76 Cause – Problem detected with relay coil.
Solution – Make sure relay coil is intact.
VACC not OK
Cause –
78
Solution – This is generally a temporary problem due to certain working
conditions. If problem persists, replace inverter.
DESCRIPTION
6-27