Pre-Start Inspection - JLG X1000AJ Operation And Safety Manual

SECTION 2 - PREPARATION AND INSPECTION

Pre-Start Inspection

The Pre-Start Inspection should include each of the fol-
lowing:
1. Cleanliness – Check all surfaces for leakage (oil,
fuel, or battery fluid) or foreign objects. Report any
leakage to the proper maintenance personnel.
2. Structure - Inspect the machine structure for
dents, damage, weld or parent metal cracks or
other discrepancies.
Parent Metal Crack
3. Decals and Placards – Check all for cleanliness
and legibility. Make sure none of the decals and
placards are missing. Make sure all illegible decals
and placards are cleaned or replaced.
2-4
Weld Crack
IF THE MACHINE DOES NOT OPERATE PROPERLY, TURN OFF THE MACHINE
IMMEDIATELY! REPORT THE PROBLEM TO THE PROPER MAINTENANCE PER-
SONNEL. DO NOT OPERATE THE MACHINE UNTIL IT IS DECLARED SAFE FOR
OPERATION.
4. Operation and Safety Manuals – Make sure a
copy of the Operation and Safety Manual, AEM
Safety Manual (ANSI markets only), and ANSI Man-
ual of Responsibilities (ANSI markets only) is
enclosed in the weather resistant storage con-
tainer.
5. Walk-Around Inspection – Refer to Figure 2-1.
6. Battery – Charge as required.
7. Fuel (Combustion Engine Powered Machines) –
Add the proper fuel as necessary.
8. Engine Oil Supply (Combustion Engine Powered
Machines) - Ensure the engine oil level is at the Full
mark on the dipstick and the filler cap is secure.
9. Hydraulic Oil – Check the hydraulic oil level.
Ensure hydraulic oil is added as required.
10. Function Check – Once the "Walk-Around"
Inspection is complete, perform a functional check
of all systems in an area free of overhead and
ground level obstructions. Refer to Section 4 for
more specific operating instructions.
3121783