Retracting The Outriggers; Boom/Platform Operation - JLG X1000AJ Operation And Safety Manual

SECTION 4 - MACHINE OPERATION

Retracting The Outriggers

(Reference Figure 4-6. on page 4-21 for item number location)
Either - Press and hold button no. 1 (item
1) of the remote control.
The 4 outriggers will all retract at the same
AUTO
time and lower the machine.
1
or
Operate each outrigger separately by
MANUAL
pressing button 2 (item 2) to select which
outrigger to control (each outrigger is num-
bered 1 thru 4, see decal at each outrigger,
each press of button 2 displays the outrigger
selected on the LCD display). Press button 1
SELECT
(item 1) to retract that outrigger.
2
Note: To cycle back to outrigger auto-
retract mode, press button 2 (item 2) until
the LCD display shows the normal operat-
ing icons.
4-18
4.7

BOOM/PLATFORM OPERATION

THE BOOM WILL NOT OPERATE UNTIL THE OUTRIGGERS ARE PROPERLY SET
AND MACHINE IS LEVELED.
AT PLATFORM/REMOTE CONTROL STATION, TWIST EMERGENCY STOP BUT-
TON CLOCKWISE TO THE OUT POSITION, START ENGINE, AND ACTIVATE
FOOTSWITCH FOR ALL PLATFORM/ REMOTE CONTROL FUNCTIONS.
ALWAYS STOW (RAISE) THE LADDER AFTER ENTERING OR EXITING THE PLAT-
FORM TO PREVENT IT BEING DAMAGED WHEN OPERATING THE MACHINE.
If the operator attempts to raise the JIB with more than the
allowed capacity in the platform a maximum weight
reminder icon appears in the middle of the platform LCD dis-
play and the function stops.
If the machine is set up on outriggers for the reduced oper-
ating area, the swing function will be stopped if and when
you try to go outside the allowed working area. A message
on the platform LCD display will appear informing that it is
necessary to swing in the opposite direction to continue
operation.
NOTE: At low temperatures start the motor and let it run for a
few minutes, so that the hydraulic oil circulates and
reaches at least 50°F (10°C) before operating the plat-
form.
3121783