Machine Realignment Emergency Procedure - JLG X1000AJ Operation And Safety Manual

SECTION 5 - EMERGENCY PROCEDURES

Machine Realignment Emergency Procedure

THIS OPERATION MUST ONLY BE PERFORMED WITH THE
BOOMS AND JIB FULLY LOWERED AND RETRACTED TO
THE WORKING POSITION.
During transport, the turntable may swing and become out
of alignment with the base. If this occurs, one of the two
EMERGENCY PROCEDURES given below can be used:
Machine Realignment:
1. Open the ground control station.
Remove key and insert it into the bypass key
2.
switch (1). Turn switch (right/left) and hold to
activate bypass button (2). The bypass icon will be
displayed.
3.
Press the bypass button (2) to
activate bypass mode and operate
the appropriate swing function to
bring the machine into alignment
while keeping bypass key turned.
3121703
4. Once machine is aligned, return bypass key to
its neutral position and return key to its
fastener.
NOTE: In case of machine with restricted work area, the
bypass of the safety devices does not allow the boom
assembly to go out of the working area related to that
outrigger configuration.
5-9