Component Maintenance Intervals - JLG X1000AJ Operation And Safety Manual

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
Table 6-10.
Component
Extension Arm Internal Sliding Ring (if equipped) Check Wear
Turntable Bolt Tightening
Platform Mount Pin Nuts
Extension Ropes and pulleys (if equipped)
* 1st time interval then per chart thereafter
** At least every 3 months or 1000 hrs. of operation
SERV...
*** At lease every 5 years or 2000 hrs of operation. Check every year. If torque is not correct, replace the nuts with new nuts of same specification.
Install dry without using grease or oil to specified torque.
**** At least once a year. Replace nuts if not properly torqued.
6-10
Component Maintenance Intervals - X1000AJ/X33JP - with Diesel Engine
Operation
Replace
Check
Check torque 148 ft. lb. (200 Nm)
Check Wear
Replace
Pre-Start As Needed
10
Hours
50 100 250 500 1000 2000
•
•
•* •
•****
•**
3121783
•*
•***