JLG X1000AJ Operation And Safety Manual page 85

SECTION 4 - MACHINE OPERATION
THE BATTERY CHARGER SUPPLIED WITH THE LIFT WAS DESIGNED TO
ENSURE SAFE AND RELIABLE PERFORMANCE. IT IS ALREADY FITTED ON THE
MACHINE AND DOES NOT NEED ANY ADJUSTMENT OR CONFIGURATION BY
THE USER; NONETHELESS, TO AVOID INJURY AND DAMAGE TO THE BATTERY
CHARGER, THE FOLLOWING ESSENTIAL PRECAUTIONS MUST BE OBSERVED:
• Carefully read installation instructions contained in this
manual. For future reference, keep manual in a safe
place.
• Do not place battery pack near heat sources.
3121783
2
• As battery charger is sealed without forced ventilation,
its performance depends on ambient temperature and
type of installation.
• Be certain type of power supply available corresponds
to voltage specified and indicated on the battery char-
ger rating plate or in this Operation and Safety Manual.
If any questions, contact your local JLG Service Center or
the local electrical company.
• An AC class circuit breaker can be used as a protection
device for the battery charger power supply, however it
is recommended to use a class A or even better class B
device.
• In regard to safety and electromagnetic compatibility,
the battery charger features a three pin plug with
OL00630
ground, which can only be plugged into an grounded
socket. If the plug does not go into the socket, most
probably the socket is old and not grounded. In this
case, contact an electrician to have the socket replaced.
Do not use adapters to resolve ungrounded circuit plug
problems.
• Ensure power cable is undamaged. If cable is worn or
damaged, have it replaced immediately.
• If extensions or multiple sockets are used, make sure
these support total rated current.
4-27