Set-Up And Adjustments; Box Width Adjustment; Box Height Adjustment; Top Flap Compression Roller Adjustment - 3M -Matic 7000a-I Instructions And Parts List

11. Set-Up and Adjustments

11.1 Box Width Adjustment

Place box on infeed end of frame
bed and align top flap center seam
with arrows on front of upper frame.
Move in and lock side by tightening
appropriate knobs (Figure 11-1).

11.2 Box Height Adjustment

Lower top head by turning the height
adjustment crank clockwise until it
lightly presses the case (Figure 11-2).
11.3 Adjustment of Top Flap
Compression Rollers
Run the box through the machine
and press the EMERGENCY STOP
BUTTON when the box is adjacent
to the compression rollers. Move the
compression rollers in to firmly press
the top flaps together.
The standard position for the
compression rollers is shown in
Figure 11-3. In this position they
accommodate boxes from 335 to
660mm [13.25 to 26 inches] wide.
To accommodate narrower boxes from
170 to 520mm [6-3/4 to 20.5] wide.
1.
2. Move both rollers to alternate
3. Install roller assembly on machine
4. Repeat this procedure for both

11.4 Changing the Tape Leg Length

Taping heads are preset to apply 70mm [2.75 inches] long tape legs. To change tape leg
length to 50mm [2.0 inches], refer to Instructions below and also to Manual 2 or 3,
"Removing Taping Heads Procedure - Changing the Tape Leg Length".
1. Remove tape from upper taping head, raise upper assembly to convenient working height.
2. Loosen the upper taping head clamp thumb screws. Move the clamp away from the
3. Hold upper taping head applying and buffing arms from under upper assembly, slide head
4. Raise upper assembly to provide working room around lower taping head and remove
5. Lift the lower taping head straight up to remove it from the case sealer bed (Figure 11-4B).
6. Refer to Manual 2 or 3, "Adjustments—Changing Tape Leg Length", for taping head setup.
7. Replace taping heads in the reverse order of disassembly.
Taping Heads - Important! Turn off Electric Power
3M-Matic 7000a-I / 7000a3-I Pro - Type 11700
™
Page 25
44-0009-2164-1 / ECO# 0078045
Loosen hand knob and remove
compression roller assembly
from machine.
hole locations.
and tighten hand knob.
sets of compression rollers.
Release Emergency Stop Button
and turn electrical switch ON (I) .
taping head (Figure 11-4A)
forward and down to remove (Figure 11-6).
tape from taping head.
Source Document for all related Manuals/Translations
Figure 11-2
Original Instruction
Figure 11-1
Figure 11-3
International - ENG
February 2021