Infeed Conveyor Assembly; Centering Guides; Outboard Tape Roll Mounting; Tape Leg Length - 3M 40800 Instructions And Parts List

7-INSTALLATION AND SET-UP (continued)

7.7 Infeed Conveyor Assembly

1. Remove the conveyor and the package of parts
from the carton.
2. Verify that the package contains two right angled
cover plates, twelve (12) M8 x 15 hex head
screws, and eight (8) M8 fl at washers.
3. To assemble the infeed conveyor, refer to
Figure 7-9 and locate four bolt holes on
the infeed end of the case sealer frame.
4. Insert a M8 x 15 screw in each hole so that only
a few threads take hold. Do not use washers
with these screws.
5. Attach the infeed conveyor over the screws
using the inverted keyholes in the end of the
conveyor. Tighten all four (4) screws with a
13mm wrench.
6. Refer to Figure 7-10. Set the cover plates over
the joint between the conveyor and the frame on
each side and secure them with four (4)
M8 x 15 screws and M8 washers.

7.8 Centering Guides

1. Remove the two centering guides and four (4)
M6 x 20 socket head screws from the package.
2. Using a 5mm hex key wrench, attach the
centering guides to the rails with four (4)
M6 x 20 screws (two [2] in each guide) as
shown in Figure 7-11.

7.9 Outboard Tape Roll Mounting

(Lower Taping Head)
Remove the tape drum bracket assembly, spacer
and fasteners from the lower taping head. Install and
secure on the infeed end of the lower frame
(as shown in Figure 7-8).

7.10 Tape Leg Length

Taping heads are pre-set to apply 70mm [2.75
inch] long tape legs. To change tape leg length to
50mm [2.0 inch], see "Special Set-Up Procedure –
Changing the Tape Leg Length."
Figure 7-8
Lower
Taping
Head
Mounting
A
B
700rks
Figure 7-9 – Infeed Conveyor
Figure 7-10 – Cover Plates
Figure 7-11 – Centering Guides
25
2010 January