Infeed Conveyor Assembly; Centering Guides; Outboard Tape Roll Mounting; Tape Leg Length - 3M -Matic 7000r-I Instructions And Parts List

7. Installation

7.7 Infeed Conveyor Assembly

1. Remove the conveyor and the
2. Verify that package contains two
3. To assemble the infeed conveyor,
4. Insert a M8X15 screw in each
5. Attach the infeed conveyor over the
6. Refer to Figure 7-10. Set the cover

7.8 Centering Guides

1. Remove the two centering guides
2. Using a 5mm hex key wrench,

7.9 Outboard Tape Roll Mounting

(Lower Taping Head)
Remove the tape drum bracket
assembly, spacer and fasteners from
the lower taping head. Install and
secure on the infeed end of lower
frame (as shown in Figure 7-8).

7.10 Tape Leg Length

3M-Matic 7000r-I / 7000r3-I Pro - Type 11700
™
Page 25
44-0009-2165-8 / ECO# 0078045
(continued)
package of parts from the carton.
right angled cover plates, twelve (12)
M8X15 hex head screws, and
eight (8) M8 flat washers.
refer to Figure 7-9 and locate
four (4) bolt holes on the infeed
end of the case sealer frame.
hole so that only a few threads
take hold. Do not use washers
with these screws.
screws using the inverted keyholes
in the end of the conveyor.
Tighten all four (4) screws with a
13mm wrench.
plates over the joint between the
conveyor and the frame on each
side and secure them with four (4)
M8X15 screws and M8 washers.
and four (4) M6X20 socket head
screws from the package.
attach the centering guides to the
rails with four (4) M6X20 screws
(two [2] in each guide) as shown in
Figure 7-11.
Taping heads are pre-set to apply
70mm [2.75 inch] long tape legs.
To change tape leg length to
50mm [2.0 inch], see "Special
Set-Up Procedure – Changing the
Tape Leg Length."
Figure 7-8
Lower
Taping
Head
Mounting
Figure 7-9 Infeed Conveyor
Figure 7-10 Cover Plates
Figure 7-11 Centering Guides
Original Instructions
Source Document for all related Manuals/Translations
A
B
International - ENG
February 2021