Analog Inputs; Current Measurement; Figure 16: Connection Example Of Transducer With Current Output At Input Ai1 - WAGO -TO-PASS 761 Manual

WAGO-TO-PASS® 761
761-314 TO-PASS® Mobile, 4 AI
Pos : 26.11 /Serie 761 (T O-PASS)/Gerätebesc hrei bung/Ansc hlüsse/Ansc hluss 761-1xx/-2xx/-3xx AI - Ü berschrift 3 @ 3\mod_1223547356640_21.doc x @ 23694 @ 3 @ 1
5.2.3

Analog Inputs

Pos : 26.12 /Serie 761 (T O-PASS)/Wichtige Erläuterungen/Sic herheits- und sonstige Hinweis e/Gefahr/Gefahr: Nur SELV/PELV- Spannungen ansc hließ en! @ 10\mod_1309249114447_21.doc x @ 74116 @ @ 1
Only connect SELV/PELV voltages!
Only SELV/PELV voltages shall be connected to the device terminals.
Pos : 26.13 /Serie 761 (T O-PASS)/Wichtige Erläuterungen/Sic herheits- und sonstige Hinweis e/Hinweis/Hi nweis: AI Singl e Ended @ 7\mod_1268146932945_21.doc x @ 52060 @ @ 1
Analog inputs are single-ended!
The analog inputs are single-ended and the "Aix–" connections are connected
internally to the "GND" connections.
Pos : 26.14 /Serie 761 (T O-PASS)/Wichtige Erläuterungen/Sic herheits- und sonstige Hinweis e/Hinweis/Hi nweis: AI Sc hirmung @ 6\mod_1264429115025_21.doc x @ 48613 @ @ 1
Connect shielding!
Shielded cables are required for analog inputs. The cable shield must be
connected to the grounded DIN rail (see section "Connections" > "Shielding").
Pos : 26.15 /Serie 761 (T O-PASS)/Ansc hliessen/Ansc hluss beispi eleAnschl uss beis pi el 761-1xx/-2xx/-3xx AI/O I - Übersc hrift 4 @ 15\mod_1365075163556_21.doc x @ 116492 @ 4 @ 1
5.2.3.1

Current Measurement

Pos : 26.16 /Serie 761 (T O-PASS)/Ansc hliessen/Ansc hluss beispi ele/Ansc hlus sbeispi el 761-31x 4AI I - Abbildung @ 15\mod_1365081727429_21.doc x @ 116543 @ @ 1

Figure 16: Connection example of transducer with current output at input AI1

Pos : 26.17 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.0.0
Connect Devices 39