Filling The Fresh-Water Tank; Filling The Spray Tank - Toro Multi Pro 5800-G Operator's Manual

no single material which is perfect for all foreseeable
applications.
Some chemicals are more aggressive than others
and each chemical interacts differently with various
materials. Some consistencies (e.g., wettable
powders, charcoal) are more abrasive and lead to
higher wear rates. If a chemical is available in a
formulation that would provide increased life to the
sprayer, use this alternative formulation.
As always, remember to clean your sprayer and spray
system thoroughly after all applications. This ensures
that your sprayer has a long and trouble-free life.
Note:
If you have questions or need additional
information regarding the spray-control system, refer
to the Operator's Manual supplied with the system.
Filling the Fresh-Water
Tank
Always fill the fresh-water tank with clean water before
handling or mixing any chemicals.
The fresh-water tank is located on the ROPS, behind
the passenger seat (Figure
Note:
It supplies a source of fresh water for you to
wash chemicals off your skin, eyes, or other surfaces
in the case of accidental exposure.
•
To fill the tank, unscrew the cap on the top of the
tank, fill the tank with fresh water, and tighten the
cap.
•
To open the fresh-water tank spigot, turn the lever
on the spigot.
Figure 25
1. Filler cap
2. Fresh-water tank
25).
g032530
3. Spigot

Filling the Spray Tank

Important:
Ensure that the chemicals you use are
compatible with Viton™ (see the manufacturer's
label; it should indicate if it is not compatible).
Using a chemical that is not compatible with Viton
will degrade the O-rings in the sprayer, causing
leaks.
Important:
The tank-volume markings are for
reference only and cannot be considered accurate
for calibration.
Important:
After filling the tank for the first time,
check the tank straps for any play. Tighten as
necessary.
1. Stop the machine on a level surface, shut off the
engine, and engage the parking brake.
2. Determine the amount of water needed to mix
the amount of chemical you need as prescribed
by the chemical manufacturer.
3. Open the tank cover on the spray tank.
Note:
The tank cover is located in the center
of the top of the tank. To open it, turn the front
half of the cover counterclockwise and swing it
open. You can remove the strainer under the
tank cover and clean the strainer.
4. Assemble the fill hose to the quick disconnect
fitting of the anti-siphon fill receptacle.
5. Add 3/4 of the required water to the spray tank
(Figure 26).
Important:
Always use fresh, clean water in
the spray tank. Do not pour concentrate into
an empty tank.
6. Start the engine, engage the parking brake, set
the spray-pump switch to the O
move the throttle lever to
7. Set the agitation switch to the O
30
Figure 26
position, and
N
.
HIGH IDLE
position.
N
g191616