Installing The Nozzles; Installing The Freshwater Tank; Freshwater Tank; 90° Elbow (3/4 Inch Npt) - Toro Multi Pro 41240 Operator's Manual

Wm turf sprayer
Table of Contents

Advertisement

Installing the Center Boom-Section
Hose
1.
Route the center boom-section hose as shown
in
Figure
44.
Figure 44
1. Up
2. T-fitting
3. Hose clamp
2.
Install the boom section hose over the barbed
T-fitting at the center boom section and secure
the hose with a hose clamp
Note:
Apply a coat of liquid soap to the hose
barb of the tee fitting to ease installation of the
hose.
17

Installing the Nozzles

No Parts Required
Procedure
The nozzles that you use to apply your chemicals
vary depending on the rate of application that you
need; therefore, nozzles are not supplied with the kit.
To obtain the correct nozzles for your needs, contact
your authorized Toro distributor and be prepared to
give them then following information:
The target application rate in liters per hectare, US
gallons per acre, or US gallons per 1,000 square
feet.
The target speed of the vehicle in kilometers per
hour or miles per hour.
1.
Thread or insert the nozzle into the nozzle
receptacle followed by a gasket.
2.
Slide the nozzle receptacle over the nozzle
fitting on a turret.
g028471
4. Center-boom hose
5. Center-section valve
6. Front of the machine
(Figure
44).
3.
Turn the nozzle clockwise to lock the cams on
the receptacle in place.
4.
Verify the fan portion of the nozzle.
See the Installation Instructions accompanying the
nozzles for more information.
18
Installing the Freshwater
Tank
Parts needed for this procedure:
1

Freshwater tank

1
90° elbow (3/4 inch NPT)
1
90° spigot
1

Freshwater-tank mount

4

Mount strap

4

Flange-head bolt (5/16 x 5/8 inch)

10

Flange locknut (5/16 inch)

1

Support tube (freshwater tank)

1

Jam nut (5/16 inch)

1

Bolt (5/16 x 1 inch)

2

Shoulder bolt (1/2 x 1-15/16 inches)

2

Bolt (5/16 x 2-1/4 inches)

2

Washer (5/16 inch)

Assembling the Mount Bracket to
the Freshwater Tank
1.
Assemble the freshwater tank to the
freshwater-tank mount with the 2 mount straps,
4 flange-head bolt (5/16 x 5/8 inch), and 4 flange
locknuts (5/16 inch) as shown in
Note:
Ensure that the elbow and spigot are
aligned to the same side of the tank as the
freshwater-tank decal.
31
Figure
45.

Advertisement

Table of Contents
loading

Table of Contents