Fru Information; Front-Panel Assembly - IBM 366 Problem Determination And Service Manual

5. Note where the SAS cables are connected, and then disconnect the 2 SAS
6. Squeeze the two blue release tabs.
7. Lift the SAS backplane out of the server slightly; then, disconnect the power
To install a SAS backplane, complete the following steps:
1. Connect the power cable to the replacement backplane.
2. Slide the backplane into the card guides.
3. Align the two slots in the backplane with the two guide tabs; then, press firmly
4. Reconnect the SAS cables to the backplane.
5. Replace the top cover.
6. Replace the hard disk drives.
7. Reconnect the external cables and power cords.

FRU information

Front-panel assembly

To remove the front-panel assembly, complete the following steps.
1. Read the safety information that begins on page vii, and "Handling
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the top cover and bezel.
4. Remove the DVD drive power and signal cables from the media-interposer card.
5. Note where the light path diagnostics ribbon cable is connected, and then
6. Press the blue tab on the chassis above the front-panel assembly and pull the
To install a front-panel assembly, complete the following steps:
1. Guide the light path diagnostics ribbon cable through first, and insert the
2. Connect the DVD drive power cable and signal cable.
cables from the SAS backplane.
cable and remove the backplane.
until the blue tabs secure the backplane.
static-sensitive devices" on page 112.
all external cables necessary to replace the device.
disconnect the light path diagnostics ribbon cable from the I/O board.
assembly out of the server.
assembly into the server through the front.
Release
button
Chapter 4. Removing and replacing server components
135