Factory Defaults; Memory Function - Thermo Scientific Microm HM355S Operation Manual

Operating Instructions
Display and Key Functions

Factory Defaults

Memory Function

Operation Manual HM335S
40
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
With this option, you return all settings to factory defaults.
Microm HM355S
Mode
Auto-V-Reduction
Retraction
Language
Fine
Trim
Speed
Note!
By selecting this function, language is reset to german!
Note!
e memory function is used to return to the same position as for rst cuts.
is function can only be used for the setting with which blocks are cut,
which have been embedded in the same molds.
height.
• To set the so-called " rst-cut-position", move the specimen clam-
ping forward with the coarse feed knob [B] until the specimen is
positioned close to the knife edge.
• To store this position, press the button MEMO [6] for approx. 1 sec.
"Pos. stored" is then brie y shown on the display.
• en proceed with work (trimming, rst-cuts, ne sectioning).
When the work on the block has been nished, brie y press the
MEMO button. e specimen clamping then moves backwards to
unclamp the specimen and insert a new specimen.
e specimen surface is now in the " rst-cut-position".
W !
ARNING
e stored cutting position can only be used e ectively when blocks
with the same height are cut. Neither adjustments on the knife carrier
nor the knife carrier must be moved on the consoles.
W !
ARNING
When moving the knife carrier, a new rst-cut-position must be selected.
Otherwise the danger of a collision with injuries might arise.
When turning on the instrument again later, the rst-cut-position must
be selected and stored again for safety reasons.
Factory Defaults
Cont.
100
Off
German
0,5 µm
5 µm
0
e blocks must be of similar
Thermo Fisher Scientific