Table of Contents
Advertisement
22.3. Making External Input Broadcast
Notes
• Adjust the output level of the microphone input or line input before broadcasting. When signals enter the
microphone input or line input, it is judged that there are input signals if those levels are high enough to make
the level meter flash.
• During recording, audio signals are output only from the headphone output terminal but not from the Line
output 1 nor Line output 2.
Tips
• Adjust the sound volume of the microphone input and line input with each corresponding input volume control
only.
• Signals entered to the front-mounted and rear-mounted Line input terminals are internally mixed and output.
22.3.1. Making the microphone broadcast
Separately prepare a dynamic microphone with ON/OFF switch meeting the following EV-700's input
specifications.
Microphone input specifications: −55 dB (0 dB = 1 V), 600 Ω, unbalanced, phone jack
Step 1. Connect a microphone to the front-mounted microphone input jack.
Before connecting a microphone, set the microphone switch to OFF and rotate the microphone input
volume control fully counterclockwise.
For the method to make the microphone ON/OFF setting, read the instruction manual attached to the
microphone.
Step 2. Set the microphone switch to ON, then adjust the microphone input volume while
speaking into the microphone.
Adjust the microphone input volume with the Microphone input volume control while
watching the level meter.
Take care so that "+3" LED of the level meter is not constantly lighting.
Step 3. Set the microphone switch to OFF after adjustment is complete.
Preparation for the microphone broadcast has been completed.
Step 4. Speak announcements into the microphone after setting the
microphone switch to ON when needed.
1
Microphone announcement in
progress display
Flashing
(MIC)
83
Advertisement
Table of Contents
