Rear - Toa EV-700 Instruction Manual

[Rear]

33. LAN terminal
Connect this terminal to a 100BASE-TX-compatible
network. (Ethernet RJ-45 Jack)
(See the EV-700 Setting software instruction manual.)
LINK/ACT indicator
• LINK/ACT indicator
Lights when the unit is connected to a network
or flashes during data transmission or reception.
Tip: Lights or flashes synchronously with the
front-mounted LINK/ACT indicator (21).
• 100BASE-TX indicator
Lights when connected to a 100BASE-TX network.
34. Contact control output terminals 1 through 8
Output a make contact during operation of the
unit such as during program playback.
The Control outputs 1 through 8 set using the EV-
700 Setting software are provided at the Contact
control output terminals 1 through 8, respectively.
40. Input/Output terminals
No.
1 Recording control input terminals
Delete/Clear control input terminals
2
3 Emergency play control input terminals Close these terminals when making emergency playback.
Emergency recording control input
terminals
4
Emergency stop control input
5
terminals
Error output terminals
6
Playback control input terminals
7
Stop control input terminals
8
Line input terminals
9
Line output 1 terminals
10
Line output 2 terminals
11
12
33 34
100BASE-TX indicator
Name
35
35. Contact-activated input terminals 1 − 16
Close the terminals to play a program, or to
record or delete the phrase.
(See p. 28, "ACTIVATING OPERATION BY
WAY OF EXTERNAL CONTROL.")
36. Cable clamp
Wrap the cord around this clamp to prevent the
AC adapter plug from coming off. (See p. 95,
"AC adapter input terminal.")
37. AC adapter input terminal
Connect an optional AD-246 AC adapter to this
terminal.
Tip: When applying power to this terminal and the
DC power input terminal (38) simultaneously,
the higher side voltage is supplied to the EV-
700.
38. DC power input terminal
Connect 24 V DC power to this terminal.
39. Functional ground terminal
Be sure to ground this terminal.
Close these terminals when recording phrases.
Close these terminals when deleting the recorded phrase.
Closing these terminals during playback clears the stored
playback order. (See p. 36, "Sequential storage playback.")
Close these terminals when making R.E.M. playback (p. 63).
Tip: Audio files for the emergency playback cannot be
recorded using these terminals.
Close these terminals when stopping emergency playback
or R.E.M. playback.
These terminals normally remain open, but close when a
failure occurs in the equipment or memory card.
Close these terminals when playback is made by way of
binary control. (See p. 30.)
Close these terminals when stopping playback and recording.
–20 dB*, 10 kΩ
Enter audio output from the external player for recording and
broadcast.
0 dB*, 600 Ω
Output unit's playback signals, microphone input signal, or
line input signal.
Tip: These 2 terminals output the same audio signals. Line
outputs 1 and 2 can be individually set to ON or OFF
using the EV-700 Setting software.
36
* 0 dB = 1 V
Function
37 38 39
40