Table of Contents
Advertisement
Step 4. Adjust the sound volume of the sound source to record.
Adjust the sound volume of the sound source with the Microphone
input volume control or Line input volume control while watching the
level meter.
Take care so that "+3" LED of the level meter is not constantly lighting.
Front panel
Line input volume
control
Tip
You can monitor the content of the sound source to be recorded using headphones.
Step 5. Press the Start/Stop key.
The "rEAdy" (READY) indication appears on
the Status display, then the unit will be placed
in Recording standby mode.
The Recording indicator and the dot at the
lower right corner of the Status display flash
during Recording standby.
Tip
If you do not make any front panel operation
for 5 minutes, the display's status will return to
the one in Step 3.
Step 6. Press the Start/Stop key again.
Recording will start after 3 seconds.
Remaining seconds appear from "3" to "1" on
countdown signs on the Status display.
When recording starts, the Recording indicator
lights and the "rEC" (REC) indication appears
for about 3 seconds on the Status display,
followed by the recording Phrase number
indication.
Microphone input
volume control
(READY)
Flashing
Displayed for 3 seconds.
(REC)
Phrase number display
Flashing
Flashing
Flashing
ON
23
Advertisement
Table of Contents
