Toa EV-700 Instruction Manual page 99

Symptom
Busy signal not output.
Hiss noise is broadcast.
Buzzing noise is broadcast.
EV-700 and a PC not placed
online even when connecting
between the two
activating the EV-700 Setting
software.
The "P. WAIT" indication
appears on the Status display.
The "Errxx" indication appears
on the Status display.
Possible cause
Contact control
terminals are not correctly
connected.
Control output and program
playback busy output are not
correctly set.
Microphone input
control or Line input volume
control is turned
clockwise.
Functional earth terminal is
not grounded.
LAN cable is not correctly
connected.
and
FTP communication
interrupted.
Network setting
performed correctly.
Some process is in progress
inside the unit, disabling other
processing.
(Examples)
• Other operation was executed
during CF card read.
• Other operation was executed
during recording.
An error has occurred.
output Connect the
terminals correctly.
Set the control output and program playback
busy output using the EV-700 Setting
software. (See the EV-700 Setting software
instruction manual.)
volume Turn the
counterclockwise
fully terminals are not used.
Ground the Functional earth terminal.
Check if LAN cable is correctly connected.
The LINK/ACT indicator lights or flashes
when the cable is correctly connected.
In the case of communication via the
network, check if cables connected to the
switching hub are appropriate ones and
they are connected to the correct port. (See
p. 94.)
is • Check firewall setting.
• To connect the EV-700 online, FTP
communication must be executed.
Consult your network administrator of the
facilities where the EV-700 is installed.
is not See the EV-700 Setting software instruction
manual.
Or, consult your network administrator of the
facilities where the EV-700 is installed.
Wait until the internal processing in progress
is complete, then retry operation.
Confirm the remedy in the Error list. (See
p. 100.)
Remedy
Contact control output
volume controls
when these input
fully
99