Error Output; Quick Stop Function - Toa EV-700 Instruction Manual

Digital announcer

Table of Contents

26. ERROR OUTPUT

A Make contact is output at the Error output terminals when the unit is placed in the state below.

• When an unusable memory card is inserted

• When a card error occurs

• When the unit malfunctions (In this case, an error code will appear on the Status display. See p. 100, "Error

List.")

• When the unit's power is off

A Quick stop function is a function that stops playback instantly when the Start/Stop key is pressed during

program playback even in the Lock mode.

Use the EV-700 Setting software to perform the Quick stop function setting.

If you wish to stop playback instantly using the Start/Stop key, enable the Quick stop function.

For the setting procedures, see the EV-700 Setting software instruction manual.

Tips

• This function is disabled by default.

• When the Quick stop function is enabled, you can stop playback by pressing the Start/Stop key during

emergency playback or R.E.M. playback even in Lock mode.

• Program playback will not stop when it is started by Level signal input activation.

• To stop recording through the front panel operation while in Lock mode, press the menu key to cancel Lock

mode, then the Start/Stop key whether or not the Quick stop function is set.

Error output terminals

Table of Contents