Table of Contents
Advertisement
22.3.2. Making the Line input broadcast
For an external audio player connected to the line input, separately prepare the one meeting the following EV-
700's input specifications.
Line input specifications: −29 dB (0 dB = 1 V), 10 k Ω, RCA jack (front-mounted line input)/−20 dB (0 dB = 1 V),
External audio player
Step 1. Connect an external audio player to the Line input terminal.
Before connecting an external audio player, rotate the Line input volume control
fully counterclockwise.
Step 2. Start the external audio player, then adjust the line input volume.
Adjust the line input volume with the Line input volume control while watching the level meter.
Take care so that "+3" LED of the level meter is not constantly lighting.
Step 3. Stop the external audio player.
Preparation for the Line input broadcast has been completed.
Step 4. Play the audio sources using the external audio player when
needed.
Note
Depending on the priority level setting, the line input broadcast may be interrupted if the higher-priority broadcast
is initiated during broadcast.
In this case, check the broadcast priority level setting. (See the EV-700 Setting software instruction manual.)
Tips
• Stereo input signals, if entered, are converted into monaural signals after the left and right channel signals
are internally mixed.
• Signals entered to the Line input terminal and those entered to the Line input terminals in the rear-mounted
block terminal are internally mixed.
84
10 k Ω, Removable terminal block (rear-mounted line input)
1
1,2
When connecting an external audio player to
the unit's rear-mounted terminals
External audio player
Flashing
Line input broadcast in
progress display
(LINE)
Advertisement
Table of Contents
