Table of Contents
Advertisement
11.2. Stopping Program Playback
Program playback automatically stops after the preset repeat count of broadcasts when set to Pulse signal
input activation (p. 33), but you can stop it manually.
Program playback can be stopped following the procedures below even if it is started in any of the methods
using the EV-700 Setting software, control input, or through front panel operation.
Tip
When the Quick stop function is set to "Enabled," you can stop playback by simply pressing the Start/Stop key
even while in Lock mode. (Seep. 88, "QUICK STOP FUNCTION.")
Step 1. Press the Menu key to select the play mode.
Press the Menu key some times until the Play mode indicator lights.
Step 2. Press the Start/Stop key.
Playback stops and the Play indicator goes off.
Tip
After you finish all necessary operations, it is recommended that you
place the unit in Lock mode to prevent accidental operation.
(See p. 27, "Disabling Each Key Operation on the Front Panel (Lock
Mode).")
ON
21
Advertisement
Table of Contents
