Adjustable Parameters - Siemens SIMATIC S7-300 Manual

6.4.2

Adjustable parameters

Introduction
For information on programming analog modules, refer to the chapter
modules
Parameters
Table 6-11 Overview of parameters of SM 331; AI 8 x 16 Bit
Parameters
Enable
Hardware interrupt when limit
•
value is exceeded
Hardware interrupt at end of cycle
•
Diagnostic interrupt
•
Hardware interrupt trigger
High limit
•
Low limit
•
Diagnostics
Group diagnostics
•
Wirebreak monitoring
•
Measurement
Module operating mode
•
Noise suppression
•
Smoothing
•
Measuring method
•
Disabled
Voltage
Current (4-wire transducer)
See also
Programming analog modules (Page 5-31)
Diagnostic messages of analog input modules (Page 5-33)
S7-300 Automation System Module data
Manual, 08/2006, A5E00105505-04
6.4 Analog input module SM 331; AI 8 x 16 Bit; (6ES7331-7NF10-0AB0)
.
Range of values
yes/no
yes/no
Yes/no
32511 to -32512
-32512 to 32511
Yes/no
Yes/no
8 channels
•
4 channels
•
50 Hz
60 Hz
400 Hz
50/60/400 Hz
None
•
Low
•
Average
•
High
•
Measuring range
•
± 5 V
•
1 to 5 V
•
± 10 V
•
0 mA to 20 mA
•
4 mA to 20 mA
•
± 20 mA
•
Defaults Parameter type
no dynamic
no dynamic
no dynamic
- Dynamic
-
Dynamic
No static
No
Yes Dynamic
No
50/60/400 Hz
None Dynamic
Dynamic
± 10 V
4 mA to 20 mA
Analog modules
Programming analog
Scope
Module
Channel
Channel
Channel
Channel
Module
Channel group
Channel group
Channel group
6-23