Siemens SIMATIC S7-300 Manual page 101

Technical data
Current consumption
from the backplane bus
•
from load voltage L1 (no-load)
•
Power loss of the module
Status, interrupts, diagnostics
Status display
Interrupts
Diagnostics functions
Group error display
•
Actuator selection data
Output voltage
with "1" signal
•
Output current
with "1" signal
•
Rated value
Permissible range
Permitted inrush current (per group)
leakage current at "0" signal
•
Output delay (resistive load)
at "1" to "0"
•
at "1" to "0"
•
Blocking voltage
zero transition
Size of the motor starter
Lamp load
Wiring two outputs in parallel
for redundant load control
•
for performance increase
•
Control of a digital input
Switching frequency
with resistive load
•
with inductive load to IEC 947-5-1, AC 15
•
with lamp load
•
Short circuit-proof output
Wiring the actuators
*The necessary front connection version is needed twice here
S7-300 Automation System Module data
Manual, 08/2006, A5E00105505-04
3.18 Digital output module SM 322; DO 32 x 120/230 VAC/1 A; (6ES7322-1FL00-0AA0)
max. 190 mA
max. 10 mA
typ. 25 W
green LED per channel
No
Yes
red LED (SF)
min. L1 (-0.8 V)
1 A
10 mA to 1 A
10 A (for 2 AC scan cycles)
max. 2 mA
1 AC cycle
1 AC cycle
max. 60 V
max. size 4 to NEMA
max. 50 W
supported (only outputs of the same group)
not supported
supported
max. 10 Hz
max. 0.5 Hz
1 Hz
No
with 20-pin* front connector
Digital modules
3-53