Connecting Loads/Actuators To Current Outputs - Siemens SIMATIC S7-300 Manual

4.7.2

Connecting loads/actuators to current outputs

Connecting loads to current outputs
Always connect loads to Q
output.
Connecting loads to a current output of an electrically isolated analog output module
Figure 4-19
Connecting loads to a current output of a non-isolated analog output module
Figure 4-20
See also
Connecting loads/actuators to analog outputs (Page 4-20)
S7-300 Automation System Module data
Manual, 08/2006, A5E00105505-04
and to the reference point of analog circuit M
I
Connecting loads to a current output of an electrically isolated analog output module
Connecting loads to a current output of a non-isolated analog output module
Priniples of analog value processing
4.7 Connecting loads/actuators to analog outputs
of a current
ANA
4-23