A.2 Parameters Of Digital Input Modules - Siemens SIMATIC S7-300 Manual

Note
To enable diagnostic interrupts in the user program at data record 1, you first need to enable
diagnostics at data record 0 in
Structure of data record 1
The figure below shows the structure of data record 1 for the parameters of digital input
modules.
You enable a parameter by setting a logical "1" at the corresponding bit.
Figure A-1
See also
Diagnostics of digital modules (Page 3-9)
S7-300 Automation System Module data
Manual, 08/2006, A5E00105505-04
STEP 7
Data record 1 for parameters of digital input modules
Parameter sets of signal modules

A.2 Parameters of digital input modules

.
A-3