Carburetor Adjustment; Basic Setting - Stihl TS 700, TS 800 Service Manual

2
1
: Examine the adjusting cone (1)
and sealing ring (2) for signs of
damage or wear.
– Replace the low speed screw
with sealing ring if necessary.
– Reassemble parts in reverse
order.
– Adjust the low speed screw,
b 12.4
High speed screw
1
: Prise the limiter cap (1) off the
high speed screw with tool
5910 890 4501.
Note:
Always fit a new limiter cap.
TS 700, TS 800
: Take out the high speed
screw (1).
2
1
: Examine the adjusting cone (1)
and sealing ring (2) for signs of
damage or wear.
– Replace the high speed screw
with sealing ring if necessary.
– Reassemble parts in reverse
order.
– Adjust the high speed screw,
b 12.4
12.4

Carburetor adjustment

12.4.1 Basic setting

Only necessary if the high speed
screw H or low speed screw L has
to be replaced or for cleaning and
1
setting the carburetor.
– Remove the limiter cap from the
high speed screw, b 12.3.11
The basic setting must be made
after removing the limiter cap.
: Turn the high speed screw H(1)
clockwise until it is firmly in its
seat.
: With the high speed screw H(1) in
its seat, give it 1.5 turns
anticlockwise to obtain the basic
setting.
: Turn the low speed screw L(2)
clockwise until it is firmly in its
seat.
: With the low speed screw L(2) in
its seat, give it 1.0 turn
anticlockwise to obtain the basic
setting.
The mark (arrow) on the low speed
screw L (2) can be used to aid
adjustment.
1 2
83