Starter Rope; Guide Bushing; Repairing The Av System - Stihl TS 700, TS 800 Service Manual

9.8 Starter rope guide
bushing
Wear on the guide bushing is
accelerated by the starter rope
being pulled sideways. The wall of
the bushing eventually wears
through and the bushing becomes
loose.
– Remove the starter cover with
rewind starter,
b 9.2
– Relax the rewind spring and
remove the starter rope and rope
rotor, b 9.4
1
– Use a suitable tool to remove the
damaged guide bushing from the
starter cover.
: Place the new guide bushing (1)
in the hole in the starter cover.
1
: Insert the screw spindle (1) of the
installing tool 0000 890 2201
through the guide bushing from
inside the housing.
58
3
2
: Fit the thrust sleeve (2) and hex
nut (3).
: Tighten down the hex nut,
steadying the screw (1), until the
bushing is firmly seated.
The installing tool flares the lower
end of the rope bushing.
– Remove the installing tool.
– Reassemble remaining parts in
reverse order.
10.

Repairing the AV system

The crankcase and tank housing
are connected by vibration damping
rubber buffers and a spring.
Damaged rubber buffers must
1
always be replaced in sets.
TS 700, TS 800