Stihl TS 700, TS 800 Service Manual page 17

1
: Draw the shaft (1) out of the deep
groove ball bearings.
1
2
: Unscrew the four screws (1) and
remove them with the
compression springs (2) and
sleeves.
: Remove the flange.
16
: Remove the washer with rubber
ring.
: Pull the bearing (1) out of the
rubber ring.
2
: Remove the washer (1) and
rubber ring (2).
: Remove the circlips in front of the
deep groove ball bearings from
the grooves on both sides.
Note:
Use pliers with short rounded tips.
1
: Press both deep groove ball
bearings and the ring out of the
bearing with a drift pin (1)
4224 893 7200.
– Reassemble the parts in reverse
order.
1
Note:
Particular attention must be paid to
the following steps.
: Fit a circlip in a groove in the
bearing.
1
TS 700, TS 800