Introduction - Stihl TS 700, TS 800 Service Manual

1.

Introduction

This service manual contains
detailed descriptions of all the
typical repair and servicing
procedures for this cut-off machine
series.
Service procedures on
standardized parts and assemblies
which are used in several STIHL
power tool series are summarized in
separate service manuals.
Reference is made to these at the
appropriate points in this manual.
Refer to the illustrated spare parts
lists during all repair work. These
lists show the installation position
and order in which the individual
parts and modules should be
assembled.
Refer to the latest edition of the
relevant parts list to check the part
numbers of any replacement parts
required.
A fault on the machine may be due
to several causes. To help locate
the fault, consult the chapter on
"Troubleshooting" and the "STIHL
Service Training System" for all
function groups.
Refer to the "Technical Information"
bulletins for engineering changes
which have been introduced since
publication of this service manual.
Technical information bulletins also
supplement the parts list and
service manual until an updated
edition is issued.
2
The special tools mentioned in the
descriptions are listed in the chapter
"Special tools" of this manual. Use
the part numbers to identify the
tools in the STIHL Special Tools
manual.
It lists all the special servicing tools
currently available from STIHL.
To help you use this manual and
understand it more clearly, the text
and illustrations are marked by
graphic symbols as follows:
In the text:
: = Action to be taken
as shown in the illustration
above the text
– = Action to be taken
but not shown in the illustration
above the text
In the illustrations:
A Item pointer (short)
aDirection of movement
(long arrow)
b 4.2 = Reference to another
chapter, i.e. to chapter 4.2
in this case.
Service manuals and technical
information bulletins are intended
exclusively for the use of properly
equipped repair shops. They must
not be passed on to third parties.
1 2
3
Servicing and repairs are made
considerably easier if the clamp (3)
5910 890 2000 is used to mount the
machine on assembly stand (2)
5910 890 3100 so that one clamp
screw engages the inner 10 mm
hole (1) in the assembly stand.
To service the underside of the
machine (e.g. remove the front
handle), turn the machine upside
down and mount it so that one
clamp screw engages the outer
10 mm hole (1) in the assembly
stand.
Always use original STIHL
replacement parts.
They can be identified by the
STIHL part number, the STIH)
logo and the STIHL parts
symbol ( . The symbol may also
appear alone on small parts.
TS 700, TS 800