Stihl TS 700 Quick Manual

14” cut-off saw

Hide thumbs Also See for TS 700:

SPECIFICATIONS:

2 Cycle Engine

9,800 RPM

50:1 Mixture

6.1 Cu In. - 6.7 bhp

Fuel Capacity: 26.2 oz.

Depth: 4.9"

Arbor: 20 mm

Weight: 26.2 lbs

• Unit will be sent with 50:1 gas mixture, wrench and goggles.

• Use only in well ventilated areas. Gas fumes are hazardous!

• Area must be clear of any debris before cutting.

• Determine what type of material is to be cut. Asphalt, concrete, metal and ductile blades are

available. 6300 rpm or faster are required.

• Blades must have a 20mm arbor.

• SHUTDOWN: Allow engine to idle down approximately 5 minutes to reduce engine heat

from burning protective coating of oil in cylinder.

• Customer should clean air filter after every four hours of usage.

• Customer will be instructed on proper filter and gasket combination. Exploded view diagram

provided on back of page.

• Consult owner's manual for changing position of blade.

• Customer will be charged for any clean up or damage due to neglect.

14" CUT-OFF SAW

Gas Powered Stihl 700

04-015

Table of Contents

Do you have a question about the TS 700 and is the answer not in the manual?

Page 1 04-015 14” CUT-OFF SAW Gas Powered Stihl 700 SPECIFICATIONS: 2 Cycle Engine 9,800 RPM 50:1 Mixture 6.1 Cu In. - 6.7 bhp Fuel Capacity: 26.2 oz. Depth: 4.9” Arbor: 20 mm Weight: 26.2 lbs PROCEDURES: • Unit will be sent with 50:1 gas mixture, wrench and goggles.
Page 2 Troubleshooting: If the unit does not start: 1. Check to make sure the filter is not completely plugged with concrete dust. 2. Check fuel level. 3. Remove and clean spark plug. Pull start unit without spark plug to remove any excess fuel from cylinder.