Stihl TS 700, TS 800 Service Manual page 75

1
: Pull out the choke shaft (1).
– Clean the choke shaft and
guides.
– Examine the choke shaft for
signs of damage and replace it if
necessary.
1
– Slide the choke shaft into the
carburetor body.
: Slip the O-ring (1) and ring (2)
onto the choke shaft.
: Push the spring (1) onto the
choke shaft.
74
2
: Push the spring (2) back and fit
the circlip (1) in the groove of the
choke shaft.
– Check correct functioning and
easy movement.
2
– Turn the choke shaft until the flat
area is visible.
: Slide the choke shutter (1) into
the slot in the choke shaft with the
recess (2) first.
Note:
Ensure that the marks (arrow) on
the choke shutter are visible as
indentations.
1
1
: Insert the screw (1) in the flat side
– Close the choke shutter (2) and
– Tighten down the screw.
– Tightening torques, b 3.6
– Check correct functioning and
2
– Secure the screw with Loctite,
1
– Check correct functioning and
1
2
of the shaft and tighten it down
moderately.
centre it in the bore of the
carburetor body.
easy movement.
b 14.
easy movement again.
TS 700, TS 800