Stihl TS 700, TS 800 Service Manual page 39

– The rubber buffers, tensioner,
handlebar support and spring
must be removed in order to
replace the clutch side of the
crankcase.
– Remove the rubber buffers,
b 10.2
– Remove the tensioner,
b 5.6
– Remove the handlebar support,
b 10.1
– Remove the spring, b 10.3
1
– Heat the area of the ball bearing
seat on the ignition side of the
crankcase to approx. 150 °C (302
°F).
: Push the ignition side ball bearing
(1) home into its seat by hand.
Note:
This must be done quickly, as the
bearing absorbs heat and begins to
expand.
38
1
: If it is not possible to heat the
ignition side of the crankcase,
use press arbor (1)
4119 893 7205 to press home the
deep groove ball bearing as far
as the stop.
1
– Heat the area of the ball bearing
seat on the clutch side of the
crankcase to approx. 150 °C
(302 °F).
: Push the clutch side ball bearing
(1) home into its seat by hand.
Note:
This must be done quickly, as the
bearing absorbs heat and begins to
expand.
1
: If it is not possible to heat the
clutch side of the crankcase, use
press arbor (1) 1124 893 7200 to
press home the deep groove ball
bearing as far as the stop.
: Place the cylindrical stub of the
crankshaft in the clutch side ball
bearing of the crankcase.
1
: Fit the drilled plate (2) 5910 893
2102 and spindle 5910 890 1800.
: Screw the threaded sleeve (1)
5910 893 2421 onto the spindle
when it has been screwed in
completely.
TS 700, TS 800
2