Stihl TS 700, TS 800 Service Manual page 65

1
: Slide the switch shaft (1) into the
left-hand bearing (arrow) on the
tank housing and then place it in
the right-hand bearing.
2
1
: Slide the stub of the bearing (1)
into the opening in the leaf spring
(arrow) and fit it over the stub of
the switch shaft (2).
– Press the bearing with switch
shaft downwards.
– Insert the screw in the bearing.
– Tightening torques, b 3.6
– Check correct functioning.
– Reassemble remaining parts in
reverse order.
64
11.2 Throttle trigger / interlock
lever
– Remove shroud, b 7.4
– Remove the air filter, b 12.1
– Remove the air filter base,
b 12.1.1
2
Removing the throttle trigger
: Push the throttle rod (1) down
and out of the throttle trigger (2).
1
: Drive out the e-clip (1) with a
suitable tool.
Note:
The e-clip may pop out as it is
removed.
: Drive out the axle pin (1) and
remove the washer (2).
1
: Unhook the torsion spring (1)
from the throttle trigger (arrow).
: Unhook the throttle trigger (1)
from the interlock lever and
remove it from the handle of the
tank housing.
1
2
1
1
TS 700, TS 800