Abrasive Wheel Drive; Bearing With Guard - Stihl TS 700, TS 800 Service Manual

5.

Abrasive wheel drive

5.1

Bearing with guard

2
1
– Test radial and axial truth of
running, b 5.2
: Release hose clip (1), remove
hose retainer (2) and disconnect
hose (3).
During installation, ensure that the
hose clip (1) does not touch the
handlebar.
: Relax the ribbed V-belt by turning
the hexagon of the tensioner
anticlockwise until the arrow
points to the left (to "0").
TS 700, TS 800
1
3
: Remove screws (1) from bearing
and remove guard.
1
: Unhook the ribbed V-belt (1) from
the belt pulley and remove the
bearing with guard.
1
: Remove screw (1) from the thrust
washer (2).
– Remove the thrust washer.
1
: Remove axial clamping ring from
the shaft.
: Remove thrust washer (1).
: Block the belt pulley (arrow).
: Unscrew the nut (left-hand
thread) and remove the belt
pulley.
1
2
: Remove the key (1) from the
groove in the shaft.
: Remove the washer (2) from the
shaft.
1
2
15