Crankshaft - Stihl TS 700, TS 800 Service Manual

– Align the assembly tool so that
the edge number 19 is at the
bottom.
: Insert four M5x72 screws
(arrows) in the holes marked "19"
and tighten them down against
the drilled plate.
1
: Turn the spindle (1) anticlockwise
until the ignition-side half of the
crankcase is pulled off the

crankshaft.

– Remove the gasket from the
crankcase.
35,4
48,0
41,8
Note:
Assembly tools without holes
marked "19" can be reworked as
illustrated.
The diagram shows the drilled plate
as seen from below.
36
: Drive the crankshaft (1) out of the
crankcase half on the clutch side.
2
: The crankshaft (1), connecting
rod (2) and needle bearing in
between are an inseparable unit.
They must always be replaced as
a complete unit.
Note:
The deep groove ball bearings and
oil seals must always be replaced
when installing a new crankshaft.
15,2
1
: Remove the oil seal on the
ignition side with a suitable
punch.
1
: Drive the deep groove ball
bearing on the ignition side out
towards the inside of the
crankcase with press arbor (1)
4119 893 7205.
: Remove the oil seal on the clutch
side with a suitable punch.
1
TS 700, TS 800